Sitemap 
IDC Tool:-
First lay the wires over the top of the IDC block :-
Then use the IDC tool to push the wire firmly into the block, note the tool will only fit one way :-
& that is it!!
How to use an IDC tool
1 post
• Page 1 of 1
How to use an IDC tool
by admin » Fri Jan 22, 2010 9:08 am
To use an IDC tool is very simple, there is no need to remove the insulation from the wire.
IDC Tool:-
First lay the wires over the top of the IDC block :-
Then use the IDC tool to push the wire firmly into the block, note the tool will only fit one way :-
& that is it!!
IDC Tool:-
First lay the wires over the top of the IDC block :-
Then use the IDC tool to push the wire firmly into the block, note the tool will only fit one way :-
& that is it!!
-
admin - Site Admin
- Posts: 13
- Joined: Thu Jan 21, 2010 12:05 pm
- Location: Telford, Shropshire
1 post
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 0 guests
