XTE-2005 Clone ADSL Faceplate for NTE5 Socket

This faceplate gives you the same benefits as the NTE5/BT Broadband Accelerator bell wire filter with the ADDITION of ADSL filtering!

The XTE2005 clone replaces the lower half of a BT NTE5 Master socket. Manufacturer part number F-500UK

Click Here to view installation instructions.

The XTE2005 clone ADSL faceplate (F-500UK) can be installed to a BT NTE5 (& also CTE5) socket, supplied with cable tie & screws. The faceplate provides an ADSL modem/router outlet and a standard BT filtered telephone outlet*. IDC connectors on the rear provide FILTERED AND UNFILTERED (ADSL) extensions, ie, you only need this faceplate and not a microfilter at each extension! IDC tool required ONLY if fitting extension wiring. Run an UNFILTERED ADSL extension off the front or rear using a BT NTE2000 extension kit for example.

*The faceplate features a standard BT socket for telephone connection and an RJ45 socket for ADSL connection-the RJ45 socket will accept both RJ45 AND RJ11 (as featured on most ADSL modems/routers) plugs.

·   Electronically isolates the high speed DSL data stream from the voice band
·   Easy installation; Tidy solution
·   Replaces phone socket(lower half) portion of NTE5 master plate
·   IDC termination to extension socket(s)
·   BT SIN346 compliant, Fully compatible with ADSL, MaxDSL, ADSL 2 and ADSL 2+

Sorry, this item is discontinued, alternatives listed below.

See full product listing here

BT to RJ45.com is a trading division of run-IT-direct VAT Number 869571663

TERMS & CONDITIONS